Driven 2-part pallet roller conveyors with cover plates

For coupling of driven conveyors.

The 2-part roller conveyors make it possible to lead pallets from a roller conveyor in position for collection by hand lift truck.

Available with right or left side-mounted gear motor and with or without capacitive sensor at pick-up end.

The cover plates prevent you from getting caught between the rollers.

  • Item no.
  • Specifications
  • Width Length Rp 7"* Motor left side
    Item no.
    Quantity Rp 7"* Motor right side
    Item no.
    Quantity
    38 1/4" 59" 480741521 480741421
    46" 59" 480742521 480742421
    54" 59" 480743521 480743421
    *Distance between the roller centres. All measurements are in inches. Subject to alteration.
  • Specifications
    Surface treatment Electro galvanized steel with the exception of gear motor, chain, and roller axles. Rollers are electro galvanized with yellow crome.
    Frames Cold-bend angle profiles bolted to C-profile cross bars with supports.
    Rollers Ø 3 1/8" electro galvanized steel tubes.
    Axle diameter Ø 5/8".
    Bearings 6203 - 2rs.
    Roller fittings Rollers are suspended between side frames by means of M10 axle.
    Payload For use up to 2205 lbs load per pallet and motor unit. Maximum suitable load is determined by several factors like speed of operation, width of conveyor, and shape and width of the pallets. If in doubt, please contact SOCO SYSTEM.
    Standard height The total height from floor to top of rollers is 3 1/2".
    Chain drive Chains operate beneath roller surface. Chain drive is from roller to roller. ½" sprockets of hardened steel are integrated with the bearing of the roller.
    Chain cover Chains are protected by a U-profile mounted above the chains. The chain cover is beneath the roller level to ensure access to pallets from both sides of the conveyor.
    Gear motor 0.37 kW. Worm reduction gear sidemounted on conveyor frame.
    Speed 37 ft/min (other speeds available).
    Subject to alteration.